Ramsey-winch 100K WILDCAT WINCH Manuel d'utilisateur

OPERATING, SERVICE AND MAINTENANCE MANUAL WILDCAT SERIES 100,000 LB INDUSTRIAL WINCH CAUTION: READ AND UNDERSTAND THIS MAN

9. Remove (8) cover bolts #33, cover #12, and o-ring #60. 10. Remove snap ring #67, and sun gear #18. 11. The planetary carrier assembly #2 may now

14. Using a nylon strap, support ring gear #22 from a hoist or boom, this ring gear is heavy. Remove (8) bolts #37 leaving the top most bolt for las

16. Remove the clutch cylinder #407 by removing the (2) cotter keys #404 and (2) pins #406 from either end of the air cylinder #407. 17. The clutch

19. By removing snap ring #67 and ball bearing #30, the input shaft #23 may be removed. 20. To remove the motor end bearing #20, support drum #16 w

21. While continuing to support the drum #16, remove the clutch #10, snap ring #68 and spacer #26. 22. The output carrier assembly #23 may be slid f

27. To remove gear end bearing #21, from mounting angles #7 and #8, first remove (4) bolts #40 and (4) nuts #42 from each angle. Shaft oil seal #66 a

DISASSEMBLY OF INPUT CARRIER Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be purchased individually (see pa

15

DISASSEMBLY OF INTERMEDIATE CARRIER Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be purchased individually

17

TABLE OF CONTENTS WARRANTY INFORMATION ...

DISASSEMBLY OF OUTPUT CARRIER Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be purchased individually (see b

19

20

21

74365262533555505469135956142558571556730272631167333631260241822417437226119326672821316664192042423265116826311023403935294211515142353940526441343

23 OM-914221-0211-b PARTS LIST ITEM QTY PART N

AIR CYLINDER KIT #256131 PARTS LIST 402402409403407403404406404406405404401408ITEM QTY PART NO DESCRIPTION401 1 408422 MOUNTING BRACKET402 2 41806

25 OM-914221-0211-b 6.00152,424.75628,727.2569

Limited Warranty See warranty card for details. If field service at the request of the Buyer is rendered and the fault is found not to b

1

HYDRAULIC SYSTEM REQUIREMENTS Refer to the performance charts, below, to properly match your hydraulic system to winch performance. The charts con

CABLE INSTALLATION 1. Unwind cable by rolling it out along the ground to prevent kinking. Securely wrap end of wire rope, opposite hook, with plast

4

LUBRICATION TABLE MinAmbient&Ope rati ngMaxAmbientMax Ope rati ng80W140Syntheti c ‐25(‐32) 125(52) 225(107)75W90Synthetic ‐40(‐40) 1

INSTRUCTIONS FOR DISASSEMBLY 1. Remove wire rope from drum. 2. Drain oil from winch by removing (2) plugs #63, removing the lower plug first. 3.

5. Remove motor #53 from winch by first disconnecting hydraulic lines (see page 17), solenoid wires, and then remove (4) bolts #36. O-ring #55 may