OPERATING SERVICE AND MAINTENANCE MANUAL MODEL HD-234 LEVER STYLE INDUSTRIAL LOW-MOUNT WINCH CAUTION: READ AND UNDERSTAND THIS MANUAL BEFORE
7 4. Remove coupling (item #34) from adapter (item #1) by unscrewing four screws (item #21). Replace adapter seal (item #38) and gasket (item #27).
8 6. Remove gear housing cover (item #4) from gear housing (item #8) by unscrewing capscrews (item #20). Thread two of the capscrews into the two ta
9 10. Check clutch housing bushing (item #20) for wear. If necessary, remove old bushing and press new bushing into place. Check yoke (item #15) for
10 13. Press bearing (item #17) onto worm (item #14) Note: Be sure that thick shoulder of bearing’s outer race (side with manufacturer’s name and pa
11 15. Place gasket (item #27) onto adapter (item #1). Slide seal (item #38) onto worm. Slide tapered end of cou-pling (item #25) over end of worm
12 17. Place thrust washer (item #43) over end of drum shaft and slide down-ward until space rests on drum. Press drum downward to compress springs
13 NOTES
14 Model HD-234 LEVER STYLE DIMENSIONS SHOWN ARE INCHES OVER MILLIMETERS2.5063,55.75146,01.1228,41.3734,92.5063,51.5038,13.6292,04.56115,82.0652,3ØDR
15 351127226271411720184343213825412619323317348317402218371523163428614420291842393013301835241091236
16 Item No.Qty. Parts No. DescriptionItem No.Qty. Parts No. Description1 1 300057 ADAPTER 22 1 416040 SETSCREW - 5/16-18NC X 1/4 HX SOC HD21 316083 B
17 LIMITED WARRANTY RAMSEY WINCH COMPANY Post Office Box 581510 Tulsa, Oklahoma 74158-1510 Telephone: (918) 438-2760 FAX: (918) 438-6688 Vis
TABLE OF CONTENTS INTRODUCTION... 1 WARRANTY INFORMATION...
1 RAMSEY WINCH MODEL HD-234 PLEASE READ THIS MANUAL CAREFULLY. This manual contains useful ideas in obtaining the most efficient operation from your
2 TECHNIQUES OF OPERATION The best way to get acquainted with how your winch operates is to make test runs before you actually use it. Plan your tes
3 WINCH MAINTENANCE Adhering to the following maintenance schedule will keep your winch in top condition and performing as it should with a minimum o
4 HYDRAULIC SYSTEMS Refer to performance charts, below, to properly match your hydraulic system to the HD-234 winch performance. The charts consist o
5 TROUBLE SHOOTING GUIDE CONDITION POSSIBLE CAUSE CORRECTION Clutch inoperative or binds up. 1. Dry or rusted shaft. 1. Clean and lubricate. 2.
6 INSTRUCTIONS FOR OVERHAUL OF RAMSEY MODEL HD-234 DIS-ASSEMBLY 1. Drain oil from gear housing by re-moving plug (item #34) from bot-tom of gear hou
Commentaires sur ces manuels