Ramsey-winch RPH-20000 (QUANTUM GBX) Manuel d'utilisateur

OPERATING, SERVICE AND MAINTENANCE MANUAL MODEL RPH-20,000 INDUSTRIAL PLANETARY WINCH CAUTION: READ AND UNDERSTAND THIS MANUA

8 6. Remove output coupling (item #7) and coupling shaft (item #6) from end bearing (item #9). Examine bearings (item #13), pressed in output couplin

9 8. NOTE: DETERMINE MOUNTING CONFIGURATION OF WINCH (R.H. or L.H. MOUNTED) BEFORE ATTACHING FRONT AND REAR FRAME ASSEMBLY TO WINCH, TO ASSURE PARTS

10 10. Place (2) gear carrier assemblies into ring gear meshing carrier gears with ring gear. Make sure that ring gear and carrier assemblies are s

11 12. With pin (item #44) installed in coupling, slide coupling (item #5) over end of input shaft below. Slide coupling over end of shaft (item #12

12 41354336OIL FILL HOLE9OIL LEVEL HOLE14. Apply Permatex to threads of pipe cap (item #43). Thread pipe cap onto pipe nipple in bottom of gear hous

13 WINCH MOUNTING CONFIGURATIONSCONFIGURATIONR. H. MOUNTINGANGLE SIDECONFIGURATIONL. H. MOUNTINGANGLE SIDE

14

15 810RPH 20000 14LONGEST SPLINE5101176923243123341315423622281414284143442126272937381919472033354640392517453230203018482516

16 PARTS LIST – RPH 20000 ITEM QTY. PART # DESCRIPTION ITEM QTY. PART NO. DESCRIPTION 1 1 242157 ASSY-FRAME 25 12 418218 LO

TABLE OF CONTENTS INTRODUCTION ...

LIMITED WARRANTY RAMSEY WINCH COMPANY Post Office Box 581510 Tulsa, Oklahoma 74158-1510 Telephone: (918) 438-2760 FAX: (918)

1 Weight (without wire rope and tensioner)...375 lb. (170,0 Kg)Gear Reduction...

2 CONTROL VALVE3 POSITION4 WAY VALVE(MOTOR SPOOL)HIGH PRESSURE LINEDUAL-A & B PORT CONTROLWITH BRAKE RELEASE SHUTTLEBRAKEPORTBMOTORATYPICAL LAYOU

3 BASED ON 8.0 CU. IN/REV. MOTOR3020000WORKING PRESSURE, PSI00 500FIRST LAYER50001000015000LINE SPEED, FT/MIN200015001000 250005FIRST LAYER1015202515

4 MAINTENANCE Adhering to the following maintenance schedule will keep your winch in top condition and performing as it should with a minimum of rep

5 3283633432522263026354193/8APPLY LOC-TITE TO SETSCREW232822RODAIR CYLINDERINSTRUCTIONS FOR OVERHAUL 1. Drain oil from gear housing #9 by removing

6 3. Remove brake assembly (item #31) by removing (2) mounting screws (item #21) attaching brake to end bearing (item #8). Remove coupling (item #5

7 5. Pull drum assembly (item #2) upward from end bearing (item #9). Remove quad-rings (item #39 & #38) from grooves in drum bushings. Remove