Ramsey-winch ATV 2500 ROCKER SWITCH 256117 Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS

FOR REPLACEMENT ROCKER SWITCH KIT #256117

FOR ATV WINCH WITH REMOTE MOUNTED MANUAL SWITCH

SOLENOID ASS’Y.

BLACK W/ YELLOW

STRIPE MOTOR

LEAD

RED

BATTERY LEAD

BLACK

BATTERY LEAD

BATTERY

YELLOW WIRE

BLACK MOTOR

LEAD

GREEN WIRE

RED WIRE

ROCKER SWITCH

MOTOR

NOTE:

TORQUE SOLENOID

TERMINAL NUTS TO

35-40 IN-LBS.

TO ATV IGNITION

SPLICE

Electrical Schematic

Before Beginning Installation

1. Locate Remote Mounted Switch and Solenoid and disconnect all wiring to battery and

winch. Switch and Solenoid can be removed and discarded.

2. Disconnect negative (-) battery cable from battery. Turn off vehicle ignition.

3. Disengage winch clutch.

4. Remove hood or cowling as necessary for easier access to installation area.

5. Locate and mark mounting location for Solenoid Assembly.

6. Locate accessory wire from vehicle ignition switch that is powered only when ignition is ON. Use

this wire when splicing to Red wire on Rocker switch.

7. Make sure locations are close enough for wiring connections to be made without making alterations

to wire lengths.

OUT

1 2 3 4

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS FOR REPLACEMENT ROCKER SWITCH KIT #256117 FOR ATV WINCH WITH REMOTE MOUNTED MANUAL SWITCH1SOLENOID ASS’Y.BLACK W/ YELLOWSTRI

Page 2

CAUTION: DO NOT CONNECT NEGATIVE BATTERY CABLE ORENGAGE CLUTCH UNTIL INSTALLATION IS COMPLETE. WINCHCOULD BEGIN SPOOLING CABLE UNEXPECTEDLY CAUSINGINJ

Page 3 - PARTS LIST

11. Make sure wires are not drawn taut acrossany surfaces that could damage them. Usecable ties to anchor wires. Tie off excess.Connect Wiring to Sole

Page 4 - Limited Lifetime Warranty

Parts List (Continued)Hardware Kit, as shown at right, consists of thefollowing components:ITEM NO. QTY. DESCRIPTION1-1 2 3/8-16UNC X 1” LG HX HD GR5